Resilient Flooring Set up

Durable floor covering has a softer, more cushioned feel than hardwood or tile floors making it more comfortable on the feet and legs. Use the proper setup method based on the type of resistant floor covering varying from large sheets to individual tiles to plank sized.


You will require:

• Chalk line
• Vinyl adhesive
• Rolling pin
• Utility knife
• Heavy paper
Prepare For Vinyl Flooring
Prepare the existing floor for resilient floor covering by eliminating carpeting, completing holes and valleys with silicone caulk or smooth bumps with sandpaper.

Setting up Vinyl Tiles

1. Draw a chalk line from a corner to the reverse corner and snap the chalk line, repeat with the remaining corners. The intersection of the chalk line identifies the center point, or beginning point, of the space.
2. Location the very first tile directly over the chalk line crossway and adhere it to the surface area by peeling the paper back of the tile or applying adhesive directly to the flooring depending upon the kind of tile.
Butt the next tile tightly up to the right of the first tile, then left, above and below. Utilize a heavy rolling pin to powerfully push vinyl tiles down and eliminate air bubbles.

Setting up Sheet Vinyl or Linoleum

1. Tape several pieces of extremely heavy paper, large enough to fit the entire space. Use this paper to cut a template, utilized as a guide for sheet vinyl or linoleum.
2. Use an energy knife to cut the template, precisely fitting the space.
3. Lay the sheet vinyl on top of sheets of plywood, excellent side down. Place the template over the leading and utilize an utility knife to cut the floor covering precisely from the template.
4. Apply adhesive to the existing floor covering and location the large sheet floor covering over the adhesive, Use a heavy rolling pin to press the flooring firmly into the adhesive while getting rid of air bubbles.

Vinyl Plank Floor Installation

1. Begin at the edge of a wall to lay plank vinyl floor covering parallel to the wall.
2. Location the very first row up against the wall and affix to the existing floor with adhesive or peeling the paper from the back depending on the plank flooring. Roll out any air bubbles and press the resilient floor covering down with a heavy rolling pin.

Make end cuts with an energy knife.

3. Begin the 2nd row with a piece of plank vinyl cut in half if you want to stagger the planks so the joints do not line up. reference Continue utilizing this approach up until the entire floor is covered.
Resilient Flooring
• Purchase specific tiles for the simplest of do it yourself resistant floor installation.
• Choose plank vinyl to resemble hardwood floor covering.
• Buy sheet vinyl in order to avoid seams.
• Install resistant flooring over essentially any surface as long as it is in excellent condition.

Leave a Reply

Your email address will not be published. Required fields are marked *